ElpiAutoWheel fitment · Mitsubishi
M Mitsubishi Lancer — Bolt Pattern
The 9th-gen Lancer (2003–2010) splits by engine: small-engine trims are 4×114.3, 2.0i and up are 5×114.3 — both share a 67.1 mm hub and M12×1.5 nuts. The final 10th generation (2007–2017) settled on 5×114.3 across the range.
✓ Reviewed 2026-09-12
Base 1.3i/1.6i trims are 4-stud; 2.0i and up are 5×114.3 on the same hub and thread — check the trim before buying.
Wheel size OE 6.5Jx16 ET46 up to 7Jx18 ET46
Trims and markets vary — verify against your own wheel or the owner's handbook before buying.
Will a wheel fit?
This Mitsubishi Lancer is 5×114.3, 67.1 mm hub.
Don't know the wheel's own pattern? Measure it →
Common questions
What bolt pattern does the Mitsubishi Lancer have?
The 9th-gen Lancer (2003–2010) splits by engine: small-engine trims are 4×114.3, 2.0i and up are 5×114.3 — both share a 67.1 mm hub and M12×1.5 nuts. The final 10th generation (2007–2017) settled on 5×114.3 across the range. Check the table above for your exact generation, and confirm against a wheel or the owner's handbook before buying.
Will other wheels fit my Lancer?
Only wheels with exactly the same bolt pattern — bolt pattern has no working tolerance. The centre bore must also be equal to or larger than the hub (a larger bore just needs spigot rings). A different pattern needs bolt-on adapters, which also push the wheel outward and change the track.
What is the centre bore on a Lancer?
67.1 mm on the current car — earlier generations may differ, see the table. The bore is the hole in the middle of the wheel; it has to clear the hub spigot or sit on a spigot ring.
Bolt pattern is only part of fitment. The offset (ET) decides where the wheel sits in the arch — work that out with the wheel offset calculator. For tyre sizing on a new wheel width, use the tire size calculator.