ElpiAuto

Wheel fitment · Subaru

Subaru Impreza — Bolt Pattern

One of the most stable fitments in the dataset: every Impreza generation from 1992 to today runs 5×100 on a 56.1 mm hub with M12×1.25 lug nuts (a few early-1990s WRX-spec cars used M12×1.5 instead).

✓ Reviewed 2026-09-13

G1–GU1992–now
Bolt pattern5x100Centre bore (DIA)56.1 mmThreadM12x1.25

Wheel size OE 6J×15 ET48 · up to 6.5J×16 ET55 (US-spec)

Trims and markets vary — verify against your own wheel or the owner's handbook before buying.

Will a wheel fit?

This Subaru Impreza is 5×100, 56.1 mm hub.

The wheel you are checking
×

Don't know the wheel's own pattern? Measure it →

Loading…
Useful? Share it with someone who's picking tires or wheels.

More tire calculators

Tire Size CalculatorDecode one size, see what else fits the wheelTire Size ComparisonTwo sizes side by side, with the speedometer effectTire Size ConverterWrite any size in metric or inch notationWheel Offset CalculatorPoke, strut clearance and backspacing for a new wheelTire Pressure Converterpsi, kPa and bar — with a placard chartFuel Cost CalculatorTrip cost and consumption in mpg, L/100km, km/LSpeedometer Error CalculatorHow far off the dial reads after a tire size changeTire Stretch CalculatorHow stretched a tire sits on a given wheel width

Common questions

What bolt pattern does the Subaru Impreza have?

One of the most stable fitments in the dataset: every Impreza generation from 1992 to today runs 5×100 on a 56.1 mm hub with M12×1.25 lug nuts (a few early-1990s WRX-spec cars used M12×1.5 instead). Check the table above for your exact generation, and confirm against a wheel or the owner's handbook before buying.

Will other wheels fit my Impreza?

Only wheels with exactly the same bolt pattern — bolt pattern has no working tolerance. The centre bore must also be equal to or larger than the hub (a larger bore just needs spigot rings). A different pattern needs bolt-on adapters, which also push the wheel outward and change the track.

What is the centre bore on a Impreza?

56.1 mm on the current car. The bore is the hole in the middle of the wheel; it has to clear the hub spigot or sit on a spigot ring.

Bolt pattern is only part of fitment. The offset (ET) decides where the wheel sits in the arch — work that out with the wheel offset calculator. For tyre sizing on a new wheel width, use the tire size calculator.